What Is Power Point #1 On 2002 Ford Explorer Fuse Box? (Question)

Where is the fuse box on a Ford Explorer?

  • Fuse box (located under the left hand side of the instrument panel) Fuse/CB/relay Ampere rating [A] Description 1 7,5 Power mirror, power antenna 2 7,5 High-mount stoplamp 3 15 Parking lamps 4 10 Left headlamp

Where is the fuse for the power windows on a 2002 Ford Explorer?

Check fuse #17 in the central junction box (under the dash on the driver’s side).

Where is the PCM relay on a 2003 Ford Explorer?

These relays are located on the reverse side of the passenger compartment fuse panel.

Where is the fuse for the power windows on a 2003 Ford Explorer?

That’s the fuse block under the hood adjacent to the battery.

How do you turn off anti theft on a 2002 Ford Explorer?

To disable anti theft then get in vehicle and close the door. Put key in ignition and turn from off to run 8 times. On the eighth time leave in on position and the theft light will turn off.

You might be interested:  How To Clip Shapes In Power Point? (Solved)

What is a PCM power relay?

The PCM (powertrain control module, also known as ECM or engine control module in other vehicle makes) comes with a power relay that provides battery voltage safely to the right PCM circuits. It’s a contact type relay activated with a signal wire from the ignition switch.

Where is the fuse box on a 2001 Ford Explorer?

The fuse panel is located on the left hand side of the instrument panel facing the driver’s side door. Pull the panel cover outward to access the fuses.

What is the fuel reset button on a Ford Explorer?

To reset the fuel light on a ford explorer you will need to access the fuel reset switch which is located in the glove box or in the foot well of the passenger seat area, press that switch and the fuel system will be reset.

Where is the starter relay located on a 2002 ford explorer?

The 2002 ford explorer starter relay is located in the fuse panel under the hood.

Where is the fuse box on a Ford Explorer?

Fuse box location The fuse panel is located below and to the left of the steering wheel by the brake pedal.

Will disconnecting battery reset anti-theft?

Start by removing the battery’s negative cable and leave it disconnected for five minutes then reconnect the battery. This will allow the security system to perform a hard reboot and reset the alarm protocol to help the immobilizer start working in the proper sequence.

How do I reset my Ford anti-theft system?

Key

  1. Insert the key into the driver’s side door lock.
  2. Turn the key once, but not all the way to unlock the door. Leave the key in this position for 40-60 seconds.
  3. Do this again, but turn the key in the opposite direction.
  4. Remove the key from the door, get into your Ford, and start the engine. The system should be reset.

Leave a Reply

Your email address will not be published. Required fields are marked *